DigiPlus Philippine

List of the contents of this article:

• 1,DigiPlus Philippine ParkingWhat to do if the car system fails
• 2, What is the parking brake system?
• 3, How to use the automatic parking system?
• 4. How to use BMW automatic parking function
• 5, Automatic Parking Principle
• 6, After repairing the tire, what does it mean that the dashboard shows the parking system failure?

What to do with the failure of the parking system

The methods of automatic parking failure are: check the door, check the automatic parking button, and go to the 4s store for repair.

Try to close the door again, sometimes prompting that the automatic parking failure may be that the door is not closed. Check whether the automatic parking button is jammed, and you can try to press it hard twice to solve the jamming problem.

It is recommended to check whether the friction pads and brake drums are stained. Common faults of the electronic handbrake can be eliminated by resetting the electronic handbrake, opening the car key, and stepping on the foot brake pedal.Press the electronic parking for 5 seconds, and then pull it up for 5 seconds to reset the electronic parking. The parking brake system usually refers to the manual brake installed on a motor vehicle, referred to as the hand brake.

This may be caused by the failure of the electrical or mechanical parts of the brake. The solution to this problem is to check whether the mechanical and electrical parts of the brake are working properly. If a fault is found, the vehicle needs to be sent to a professional car repair station for repair.

The solution to the automatic parking failure is as follows: check whether the parking brake is faulty. The parking brake is an important part of the automatic parking function, so when the parking brake fails, the fault light will turn on.

If the parking system fails, it needs to stop and restart the electronic parking. Operation method: first, put the vehicleTurn it on, then step on the foot brake of the vehicle, then press and hold the electronic handbrake for 5 seconds and pull the electronic handbrake up for 5 seconds, and the electronic handbrake will resume initialization. After restarting, you can return to normal use. If there is no recovery, you need to replace the accessories.

What is the parking brake system?

Parking brake, commonly known as handbrake, its function is to give the car a resistance when parking so that the car does not slip.The parking brake is the parking gear of the handbrake or automatic gear, which is used to lock the drive shaft or rear wheel. The force of the parking brake is much less than that of the driving brake. Just park on the slope and don't glide.

The parking brake is commonly known as the handbrake of the vehicle, which is part of the vehicle's brake system. When the vehicle stops and turns off, pull up the parking brake to maintain a relevant rear-wheel braking state of the vehicle to avoid the phenomenon of related slipping or displacement of the vehicle.

Parking brake, that is, the parking gear in the handbrake or automatic transmission, locks the drive shaft or rear wheel. Parking brake, generally called handbrake, is to give the car a resistance when parking, so that the car does not slip.

How to use the automatic parking system?

How to use automatic parking? My automatic car can be peded automatically. First, step on the brake pedal of the car; then press the one-button start button of the car; then the instrument of the car lights up and the power of the whole car is turned on; finally, press the autohold button in the car to turn on the automatic parking mode.

How to use: fasten the seat belt and activate the auto function while driving. During the driving process, when the vehicle stops completely, you can release the brake. There will be a parking sign on the dashboard. The car will always be stationary, and the gear can be kept in D or N gear. Tap the accelerator to release the brake. When you get out of the car, remember to change back to P gear and then pull the handbrake.

Press the automatic parking, and it will prompt ON, indicating that the function is turned on. After turning on, the driver does not need to care. The vehicle will brake the vehicle by itself according to the specific situation, and there is no need to step on the brake board all the time.When starting, step on the accelerator, and the vehicle will release the braking state by itself. If you want to turn off automatic parking, press the button again.

Use the automatic car collection function to switch the engine to P (parking gear) and pull the left dial of the vehicle to the left automatic parking gear. Step on the brake, press the reverse gear paddle, and the engine will automatically switch to reverse gear.

So in this case, the automatic parking function needs to be turned off. The operation of turning off this function is also very simple. As long as we press the "AUTO HOLD" switch again, wait for the indicator light on the switch button to turn off, and the AUTO HOLD green indicator light on the combination instrument goes out, this function will not work.

The method of automatic parking is to have an AUTOHOLD button, and the corresponding automatic parking function will be activated when the AUTOHOLD function is enabled.There is an AUTOHOLD button next to the gear. Pressing it will prompt ON.

How to use the BMW automatic parking function

1. The automatic parking system can free the driver's right foot and avoid frequent gear switching. The switch of auto h is next to the shift lever. If you want to use this function, you can turn it on, and if you don't want to use it, you can also turn it off. It is recommended that you turn off the automatic parking function when reversing and moving the car. It is not safe to use automatic parking at this time.

2. BMW's automatic parking is very simple to use. As long as the car stops, the handbrake will be automatically pulled on. At this time, the driver can stop without stepping on the brake all the time or changing to N gear. If you want to continue driving, just step on the accelerator pedal.BMW's automatic parking system has a switch next to the gear lever.

3. The parking gear is the P gear of the automatic transmission. It is used to lock the gearbox gear when parking. It refers to automatic transmission cars, which include forward gear s-d gear, reverse gear R, and idle gear N. It is generally used in towing. Parking gear P is equal to the manual gear idle plus handbrake.

automatic parking principle

1. [Pacific Automobile Network] The working principle of the automatic parking system is: the brake management system realizes the control of the four-wheel brake through the extension function of the electronic handbrake (EPB). In other words, the automatic parking system is an extension of the electronic handbrake (EPB), which is controlled by ESP components.

2. Automatic parkingThe principle is to give accurate parking force by the controller through the slope sensor. When starting, the parking control unit calculates the information provided by the clutch distance sensor clutch pinching speed sensor accelerator pedal sensor. When the driving force is greater than the driving resistance, the parking brake is automatically released, so that the car can be stable. Up.

3. The working principle of automatic parking. When starting on a slope, the traditional handbrake needs to rely on the driver to manually release the handbrake or skillfully throttle and clutch to start comfortably.

After repairing the tire, what does it mean that the dashboard shows the parking system failure?

1. Reason: The joystick of the parking brake cannot be fixed. The parking brake failed.The parking brake makes a strange sound or is aging. The gap between the friction pad and the brake drum of the automatic parking system is too large, and the friction pad and brake drum are oily or seriously worn, the rivets are exposed, and the surface is hardened, causing slippage and failure.

2. The failure of the parking system means that the automatic braking function cannot be realized due to sensor problems. The parking system refers to the function of automatic braking. The failure of the parking system is caused by sensor problems and the inability to realize the automatic braking function.

3. If the electronic parking system fails, most of them have problems with the parking or brake system switch, resulting in the start-up system not receiving the brake (braking) signal, resulting in the inability to start. Replacing the switch can solve the problem.

4. The parking system refers to the function of automatic braking. The failure of the parking system is caused by sensor problems and the inability to realize the automatic braking function.

5. Please check the electronic parking brake system displayed on the dashboard: the situation caused by the failure of the electronic handbrake of the car.

6. Yes. According to the official website of Geely, the reasons for the failure of Geely Automobile's electronic parking system are: engine failure to start, flat tires, flat tires and other faults, brake failure, electronic handbrake problems, brake pad wear, electronic system problems, and insufficient power supply problems.